Sudo chmod g+w /usr/local/etc/yate/*.conf Required Configuration Items Sudo chown root:yate /usr/local/etc/yate/*.conf This guide assumes one wants to run Yate as a non-root user, and uses a yate group to allow a non-root user to edit the various configuration files that will be manipulated at runtime. If you plan to check out the latest source code, Subversion is required. Please refer to your Linux distribution's documentation for information on how to install these. To build Yate and YateBTS, basic knowledge of how to use GNU Autotools and GCC is required. One such device that has been tested with the above SIM card is the BLU Q170T. Plenty of quad-band GSM devices are available online. To configure the sim card, please see this page about PySIM. These all appear to come preprogrammed with the IMSI 001010123456789. This "16 in 1 Super SIM" has been verified to work properly (alternative source on ebay). Be sure to review the Transceiver Scheduling Priority section below, if you plan on using USB 2.0.Ī simple and inexpensive test setup can be achieved using a blank SIM card, a SIM card writer, and low-cost cellular device. If you are on a USB 2.0 port and encounter errors (as evidenced by varying timestamp "jumps"), it may be the case that the system is not keeping up with the sample rate. When performing laboratory experiments, an RF test enclosure is highly recommended to ensure a system under test does not yield out-of-band emissions that might interfere with licensed network operators.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |